Cisco RV320 Router Firmware 1.1.0.09 Download

Posted at November 5, 2024 by PCI-DB Team

Cisco RV320 Router Firmware 1.1.0.09 Description

Changes:

- When a user configures IP/MAC binding rule, the DHCP client PC can not get a DNS address. (CSCuf30458)
- When the AH Hash Algorithm is enabled, G2G VPN behaves abnormally. (CSCuf29893)
- After a VPN tunnel is broken, the GUI still reports it as being connected. (CSCuf29807)
- Firewall rules configured by using the wizard do not work (CSCuf29786)
- Interface hangs if more than 10 port forwarding rules are created (CSCue37361)
- The Domain Name value in Setup>Network should not be mandatory. (CSCue32361)
- Bonjour does not work normally after upgrading from firmware version 1.0.1.17 to version 1.0.2.03. (CSCue20228)
- When the device is behind NAT and acts as VPN server, the data traffic cannot pass through the VPN tunnel. (CSCue12909)
- Differentiated Services Code Point (DSCP) is not being marked in the packets. (CSCud84933)
- When a 3G or 4G USB dongle is connected by using a USB port, a dongle attached to the second USB port might not function reliably. (CSCud51978)
- Multicast streams cannot pass through the device when it working in Transparent WAN Bridge mode. (CSCud49653)
- After reload, 802.1x does not work (CSCud47422)
- The device management option is not correctly managing the HTTP or HTTPS data sent to the device; the device should block only ICMP. (CSCud45072)
- When the DHCP lease time is changed, the lease time value shown on the DHCP Status page is not updated. (CSCud37623)

Installation Procedure:

- Save the downloadable package.
- Log into the router’s web user interface.
- Navigate to the firmware upgrade section of your wireless unit.
- Select the present firmware and configure your router to install this file.
- Wait as the device carries out this process.
- Reboot the unit if required.

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Cisco Drivers