NETGEAR XCM8903 Switch Firmware 11.0.0.25 Download

Posted at April 27, 2024 by PCI-DB Team

NETGEAR XCM8903 Switch Firmware 11.0.0.25 Description

Bug Fixes since 11.0.0.18

- Unknown BGP packets locked up the switch and required hard reboot to start passing traffic again.
- SFP ports are not coming up after reboot.
- There are some garbage u/s/p value in PoE log messages.
- TechSupport file corrupted after upload it through GUI.
- The port does not link up after connect XCM8924X to GS752TPS.
- The switch is not using the configured radius source interface while sending the radius packets.
- It is unable to disable LACP mode on ports on the page of Switching>Ports>Port Configuration.
- The password for RADIUS account server changed after rename the RADIUS account server's name through GUI.
- Random ports transition into invalid state in specific scenario.
- OSPFV3 Stack Master reboots when it is configured as ASBR in specific scenario.
- mDNS packets will be dropped when IGMP/MLD snooping is enabled.
- A lot of entries missing in the Neighbor Table on IPv6 GUI.
- M6100 upgraded the 10G phy to v1.09.1.
- Switch sends radius accounting requests with default interface IP instead of user configured radius source interface IP.
- Fan speed is incorrect with latest FPGA on M6100.

About Switch Firmware:

Given the large variety of models and different methods for upgrading the switch, if you wish to apply this package, we recommend that you read and understand the installation steps before you install a new firmware, even if you are a power user.

Usually the update procedure isn't much of a hassle as manufacturers try to make it as simple as possible; however, there are cases that are exceptions to this rule. First off, go to the system information page of the switch to check that the currently installed version isn't either newer or matching this release.

Applying a new firmware can decrease the security vulnerabilities, enhance overall performance and compatibility, improve various power management functions, resolve different errors, and add support for newly developed technologies and protocols.

It is recommended that you perform this step in a steady power environment such as the one ensured by a UPS unit, and that you don't interrupt the upgrade in any way, because this might cause the switch to malfunction.

That being said, click the download button, get and apply the new version, and check back with our website constantly to stay up to speed with the latest releases.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers