NETGEAR XSM7224S Switch Firmware 9.0.1.37 Download

Posted at May 9, 2024 by PCI-DB Team

NETGEAR XSM7224S Switch Firmware 9.0.1.37 Description

Changes:

- Stack issues (reboot backup unit caused the traffic got forwarded to CPU)
- Error message showed up after delete/add default IP route on XSM7224S
- Using URL http://x.x.x.x/filesystem/startup-config, user can download the config file without login
- Even if the user "logs out" using the "LOGOUT" button, the file can be downloaded
- No link on SFP module in combo slot after firmware upgrade
- Switch will crash when trying to copy command and using scp for destination
- Unable to negotiate 10Gb link with BCM57810
- Loss of connectivity when stack member reboots
- sFlow Data not being transmitted when configured on a LAG
- Loss of connectivity for virtual server static LAG when stack member reboots caused by physical switch port up during boot process
- 100M mode doesn't work on copper port on XSM7224S with some ports configured as stack ports
- Add the IP address to the ARP collision message
- After enable ping debug, the XSM7224S hang somehow
- Ping to Loopback Interface Can't Go Through When There are ARP Requests going on the switch
- Unable to ping the VRRP virtual IP address from a routed interface
- Stack reboots when Customer enable NFS
- Packetcounters in gui and snmp do not match for certain values
- XSM Stack hangs up
- Running out of DHCP IP addresses
- Online case: 3rd party HW not working
- Packets loss and IP routing
- Switch crashed when setting up VRRP
- Collector log entries
- DHCP pool stops providing new lease after few weeks.
- Getting power supply state change in logs
- Spam in logs about interface out of range.
- ACls with source port defined don't work when Source and Dest not on same switch

About Switch Firmware:

Given the large variety of models and different methods for upgrading the switch, if you wish to apply this package, we recommend that you read and understand the installation steps before you install a new firmware, even if you are a power user.

Usually the update procedure isn't much of a hassle as manufacturers try to make it as simple as possible; however, there are cases that are exceptions to this rule. First off, go to the system information page of the switch to check that the currently installed version isn't either newer or matching this release.

Applying a new firmware can decrease the security vulnerabilities, enhance overall performance and compatibility, improve various power management functions, resolve different errors, and add support for newly developed technologies and protocols.

It is recommended that you perform this step in a steady power environment such as the one ensured by a UPS unit, and that you don't interrupt the upgrade in any way, because this might cause the switch to malfunction.

That being said, click the download button, get and apply the new version, and check back with our website constantly to stay up to speed with the latest releases.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers