NETGEAR XSM7224S Switch Firmware 9.0.1.29 Download

Posted at December 22, 2024 by PCI-DB Team

NETGEAR XSM7224S Switch Firmware 9.0.1.29 Description

Changes:

- Failed to configure the igmp snooping in VLAN 1.
- Fixed 100Mbps on copper port does not work.
- Supported the command 'monitor session 1 source interface cpu'.
- GUI does not have option to delete the Static ARP.
- Syslog configuration is lost after reboot.
- It appears some problem in using port 1 to port 20 for stacking after unit rebooted.
- Faulty Fan status dosent change unless rebooted.
- Config 1/0/24+2/0/24 as ethernet port (fiber cable connect), issue reload 2, unit2 keep rebooting.
- Stacked XSM7224S seeing CPU very busy with IPMapForwader runs high after reload slave unit.

About Switch Firmware:

Given the large variety of models and different methods for upgrading the switch, if you wish to apply this package, we recommend that you read and understand the installation steps before you install a new firmware, even if you are a power user.

Usually the update procedure isn't much of a hassle as manufacturers try to make it as simple as possible; however, there are cases that are exceptions to this rule. First off, go to the system information page of the switch to check that the currently installed version isn't either newer or matching this release.

Applying a new firmware can decrease the security vulnerabilities, enhance overall performance and compatibility, improve various power management functions, resolve different errors, and add support for newly developed technologies and protocols.

It is recommended that you perform this step in a steady power environment such as the one ensured by a UPS unit, and that you don't interrupt the upgrade in any way, because this might cause the switch to malfunction.

That being said, click the download button, get and apply the new version, and check back with our website constantly to stay up to speed with the latest releases.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers