NETGEAR GSM7248R Switch Firmware 7.1.1.7 Download

Posted at December 22, 2024 by PCI-DB Team

NETGEAR GSM7248R Switch Firmware 7.1.1.7 Description

New Features/Enhancements/Bug Fixes:

- Fail to create static route with default preference via web GUI.
- Port security increase of MAC addresses from 20 to 48 per port.
- Web GUI does not allow deleting of the buffered logs.
- Web will return “The page cannot be found” error when attempt to go to “Maintenance -> Troubleshooting” page.
- Switch might crash while repeatedly configure and refresh thru HTTPS.
- Console port might hang while downloading configuration file after reset to factory default.
- SNTP: additional character shown for command 'clock timezone'
- The 100Mbps SFP fiber module showed as 1000Mbps speed after "clear config"
- Failed to assign MAC ACL to a lag interface.
- Failed to assign IP ACL to a lag interface.
- The path external-cost value in STP changed incorrectly when path cost is modified
- Web page for port channel (LAG) contains check box to have all ports to be selected as LAG members.
- Routing VLAN MAC wasn’t deleted when the routing VLAN was removed.
- Some online help web pages has various errors (e.g. spelling error, title mismatches etc.)

Known Issues:

- If the web session is in HTTPS mode, and HTTP mode is used to perform firmware download, then the download will fail.
- Workaround: Use TFTP to perform firmware download via HTTP session instead.
- If the web session is in HTTPS mode, and TFTP mode is used to perform firmware download, then there may not be a download success message displayed at the end of the download.
- Workaround: Although there may not be a completion message, but the firmware is downloaded successfully. So just ignore the absent of the success message. 

About Switch Firmware:

Given the large variety of models and different methods for upgrading the switch, if you wish to apply this package, we recommend that you read and understand the installation steps before you install a new firmware, even if you are a power user.

Usually the update procedure isn't much of a hassle as manufacturers try to make it as simple as possible; however, there are cases that are exceptions to this rule. First off, go to the system information page of the switch to check that the currently installed version isn't either newer or matching this release.

Applying a new firmware can decrease the security vulnerabilities, enhance overall performance and compatibility, improve various power management functions, resolve different errors, and add support for newly developed technologies and protocols.

It is recommended that you perform this step in a steady power environment such as the one ensured by a UPS unit, and that you don't interrupt the upgrade in any way, because this might cause the switch to malfunction.

That being said, click the download button, get and apply the new version, and check back with our website constantly to stay up to speed with the latest releases.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers