NETGEAR GSM7224 Switch Firmware 6.1.0.9 Download

Posted at December 22, 2024 by PCI-DB Team

NETGEAR GSM7224 Switch Firmware 6.1.0.9 Description

New Features/Enhancements/Bug Fixes:

- Port description feature to allow description be added to each port
- Add support for new switch model GSM7328FS
- Add “show mac-addr-table <vlan id>” command that shows mac addresses learned per VLAN
- The “show mac-addr-table” command now supports '<mac-addr>' option without requiring <vlan id> option
- Add “configure terminal” command which works the same as “configure” command
- Logical Interface name (e.g. “vlan <id>”, “lag <id>”) display changes missing in some CLI commands.
- SNMP MIB objects, etherStatsOversizePkts, etherStatsJabbers, SyRmSnRmEs, are not functioning properly.
- Port Config pop menu fails in JRE 1.6.0
- GSM73xxS: IGMP snooping not working
- Configuration script file could not be executed completely with certain configuration
- DHCP server client config show run output has bad client-identifier
- Rebooting when building 200 neighbors and receiving 2 routes from each neighbor
- GSM73xxS: Fan Status always reported as OK in show hardware output
- FSM73xxS: Diffserv Class with matching condition mac address and mask is not working.
- DHCP client: switch crashes while obtaining address from server
- SNMP SET operation not being done properly on the object - 'agentStpConfigRevision'
- RIP: wrong route will be sent when changing its subnet mask frequently
- GSM73xxS: 10G fiber ports showed media type as copper
- GSM73xxS crashes when enable/disable OSPF on the remote end more than 2 times
- SNMP: configuration script contains SNMP setup would fail to apply
- FSM7328S crash with banner file download
- SNMP: command 'no snmp-server community ipmask 255.0.255.0' failed
- SNMP: command line inconsistent with running-config
- port-channel static should be configured in "interface lag <lagid>" mode  

About Switch Firmware:

Given the large variety of models and different methods for upgrading the switch, if you wish to apply this package, we recommend that you read and understand the installation steps before you install a new firmware, even if you are a power user.

Usually the update procedure isn't much of a hassle as manufacturers try to make it as simple as possible; however, there are cases that are exceptions to this rule. First off, go to the system information page of the switch to check that the currently installed version isn't either newer or matching this release.

Applying a new firmware can decrease the security vulnerabilities, enhance overall performance and compatibility, improve various power management functions, resolve different errors, and add support for newly developed technologies and protocols.

It is recommended that you perform this step in a steady power environment such as the one ensured by a UPS unit, and that you don't interrupt the upgrade in any way, because this might cause the switch to malfunction.

That being said, click the download button, get and apply the new version, and check back with our website constantly to stay up to speed with the latest releases.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers