NETGEAR FSM7328S Switch Firmware 6.2.0.14 Download

Posted at November 5, 2024 by PCI-DB Team

NETGEAR FSM7328S Switch Firmware 6.2.0.14 Description

New Features/Enhancements/Bug Fixes:

- Add support for new POE switch FSM7328PS
- Add “save” command allows saving running config into flash with a single command
- Add “show running config interface” shows the configuration per interface
- Configure certain IGMP snooping using Web GUI, the switch might crash
- FSM7300S: Unable to bind MAC ACL list to the interface
- FSM7300S: IP ACL does not work properly
- FSM7300S: “show interface” command right after the switch is rebooted will cause the crash
- SNMP v3 packet might cause the switch to crash
- GSM7312 crashes when the client address is blank in SNMP Community config
- SNTP Server Configuration pageAddress Type" field is mistakenly configured as "DNS", device fails to update the time
- VLAN GUI config page is error in not highlighting the member
- GSM7328FS: fiber SFP link not up after module remove and reinsert
- GSM7300S/FS - master unit reboot intermittently
- GSM7300S/FS: eventlog shows corrupted entry
- FSM7326P: IGMP Snooping: 'ip igmpsnooping unknown-multicast filter' does not take effect
- When device originates ARP request for the target in secondary network with Sender IP Address as Primary Interface
- When using default IP address in network interface, copy command failed
- MFDB table do not get updated when client send IGMP leave
- The speed for the port for 1G SFP module is shown to be unknown when specific port is selected on port configuration web page
- Fails to accept host name begins with digit (0-9).
- GUI : garbage character appear when configuring policy map
- Dot1x : access fail after changing port-control from auto to force-authorized
- Port security may impede MAC address learning
- GSM7328S crashed when combo port mode is set to speed of 100Mbps
- GSM7328S could not set 100Mbps half-duplex for gigabit port
- GSM7328S port status stayed down when both sides port mode are set at 1000Mbps full-duplex.

Known Issues:

- GSM7212: Jumbo frame does not work
- Switch will not forward IS-IS packets 

About Switch Firmware:

Given the large variety of models and different methods for upgrading the switch, if you wish to apply this package, we recommend that you read and understand the installation steps before you install a new firmware, even if you are a power user.

Usually the update procedure isn't much of a hassle as manufacturers try to make it as simple as possible; however, there are cases that are exceptions to this rule. First off, go to the system information page of the switch to check that the currently installed version isn't either newer or matching this release.

Applying a new firmware can decrease the security vulnerabilities, enhance overall performance and compatibility, improve various power management functions, resolve different errors, and add support for newly developed technologies and protocols.

It is recommended that you perform this step in a steady power environment such as the one ensured by a UPS unit, and that you don't interrupt the upgrade in any way, because this might cause the switch to malfunction.

That being said, click the download button, get and apply the new version, and check back with our website constantly to stay up to speed with the latest releases.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers