NETGEAR GS748Tv5 Switch Firmware 6.3.1.9 Download

Posted at November 18, 2024 by PCI-DB Team

NETGEAR GS748Tv5 Switch Firmware 6.3.1.9 Description

Fixed issues:

- Fixed the SNMP display and conversion issues related to AgentTransferDownloadGroup and LLDRemManAddrTable
- Fixed the problem of not getting response using SNMPGet with UDP broadcast (IP: 255.255.255.255) to port 161
- Fixed the issue where system locks up when performing a SNMP GET on MIB object - dot1qVlanForbiddenEgressPorts
- Fixed the problem of unexpected result is seen when setting and getting the value of MIB object - StaticUntaggedPorts on VLAN 1
- Fixed the issue where GS748Tv5 keeps getting the following error message “Fan state change alarm: Fan ID: 1 Event: 3” in memory log
- Fixed the problem of not able to add SNTP sever with specific IPv4 address such as 172.22.6.224~254
- Fixed the problem where SNMP(v1) TRAP always shows its agent IP as 192.168.0.239
- Fixed the issue where 802.1x Authentication would fail with “Authentication Fails, Reason Code 23” in the event viewer log when PEAP is used

Known issues:

- Warning messages pop up when the HTTPS admin status is enabled.
- [Workaround]: Refresh the GUI screen.
- The cable test results sometimes show a much longer value.
- [Workaround]: Redo the cable test on the same port.

About Switch Firmware:

Given the large variety of models and different methods for upgrading the switch, if you wish to apply this package, we recommend that you read and understand the installation steps before you install a new firmware, even if you are a power user.

Usually the update procedure isn’t much of a hassle as manufacturers try to make it as simple as possible; however, there are cases that are exceptions to this rule. First off, go to the system information page of the switch to check that the currently installed version isn’t either newer or matching this release.

Applying a new firmware can decrease the security vulnerabilities, enhance overall performance and compatibility, improve various power management functions, resolve different errors, and add support for newly developed technologies and protocols.

It is recommended that you perform this step in a steady power environment such as the one ensured by a UPS unit, and that you don’t interrupt the upgrade in any way, because this might cause the switch to malfunction.

That being said, click the download button, get and apply the new version, and check back with our website constantly to stay up to speed with the latest releases.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers