EnGenius EOA3630 Repeater Firmware 1.3.1 Download

Posted at December 31, 2024 by PCI-DB Team

EnGenius EOA3630 Repeater Firmware 1.3.1 Description

EOA3630 - 802.11g Outdoor High Power 600mW Access Point / Bridge / Repeater / Router with Detachable Omni Antenna

HARDWARE SPECIFICATIONS:
MCU: Atheros AR2316, 180MHz
Memory: 32MB SDRAM
Flash: 8MB
Physical Interface:
RJ-45 10/100 Fast Ethernet
Reset Button
LED's Status:
Power (Status)
LAN (10/100Mbps)
WLAN (Wireless Activity)
Link Quality (Client Bridge mode)
Green: Excellent Quality / Yellow: Good Quality / Red: Poor Quality
Power Requirements:
Active Ethernet: (Power-over-Ethernet) Proprietary PoE Design
Power Adapter: 24V / 0.6A DC
Regulation Certifications: FCC Part 15C/15B/15E, EN301 893, EN 300 328, EN 301 489-1/-17, EN60950

RF SPECIFICATIONS:
Frequency Band: 2.412~2.484GHz
Media Access Protocol: Carrier Sense Multiple Access with Collision Avoidance (CSMA/CA)
Modulation Technology: OFDM: BPSK, QPSK, 16-QAM, 64-QAM, DBPSK, DQPSK, CCK
Operation Channels: 11 for North America / 14 for Japan / 13 for Europe
Receive Sensitivity (Typical):
IEEE 802.11g
Mbps @ -92dBm
Mbps @ -74dBm
IEEE 802.11b
Mbps @ -97dBm
Mbps @ -89dBm
Available Transmit Power (Average):
IEEE 802.11g
dBm @ 6~24Mbps
dBm @ 36Mbps
dBm @ 48Mbps
dBm @ 54Mbps
IEEE 802.11b
dBm @ 1~11Mbps
Antenna: Detachable Omni Antenna; N-Type Female; Peak Gain 5dBi

SOFTWARE FEATURES:
Topology: Infrastructure
Operation Mode: Client Bridge / Access Point / WDS AP / WDS Bridge / Client Router / AP Router / Universal Repeater
LAN: DHCP Server / DHCP Client
WAN (Client Router / AP Router mode): PPPoE
Router: NAT / NAPT
VPN: VPN pass-through (PPTP, L2TP, IPSEC)
Wireless:
Wireless Mode 802.11b / 802.11g / SuperG
Channel Selection (Setting varies by Country)
Transmission Rate 802.11b/g: 108, 54, 48, 36, 24, 18, 12, 11, 9, 6, 5.5, 2, 1 in Mbps
Transmit Output Power Control
Signal Strength
Distance Control (ACK Timeout)
Channel Bandwidth Selection 20/10/5MHz
RSSI LED Indicators (Client Bridge mode)
Auto Channel Selection
AP Detection
Multiple SSID Support (up to 4)(Access Point mode)
Preferred BSSID
Security:
WEP Encryption 64/128/152bits
WPA Personal (WPA-PSK using TKIP or AES)
WPA Enterprise (WPA-EAP using TKIP)
.1x Authenticator (Access Point mode)
.1x Supplicant-TTLS (Client Bridge mode)
Hide SSID in Beacons
.1q VLAN Tagging Support
MAC Filter (Access Point mode)
Wireless STA (Client) Connected List
QoS: WMM

MANAGEMENT:
Configuration: Web-Based Configuration (HTTP) / Telnet
Firmware Upgrade: Upgrade Firmware via Web Browser; Keep Latest Setting When Firmware Update
Administrator Setting: Administrator Password Change
Reset Setting: Reboot (Press 1 second) / Reset to Factory Default (Press 5 seconds)
System Monitoring: Status, Statistics and Event Log
SNMP: v1, v2c
MIB: MIB I, MIB II
Backup & Restore: Settings Through Web
Diagnostic: Ping & Trace-Route

ENVIRONMENT & PHYSICAL:
Temperature Range: Operation -20°C to 70°C (-4°F to 158°F) / Storage -30°C to 80°C (-22°F to 176°F)
Humidity (Non-condensing): 0%~90% Typical
Dimensions: Length: 10.24” (260mm) x Width: 6.89” (175mm) x Height: 2.56” (65mm)
Weight: 1.49lb. (680g)

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related EnGenius Drivers