Ubiquiti PBE-M5-300-ISO Bridge Firmware 6.1.3.31939 Download

Posted at November 24, 2024 by PCI-DB Team

Ubiquiti PBE-M5-300-ISO Bridge Firmware 6.1.3.31939 Description

New:

- New: TDD Framing/GPS Sync support for XM/TI devices
- New: UNMS agent upgrade to v0.1.0

Improvements:

- airMAX-ac FF: Performance and stability improvements
- AirOS stability improvements
- AirOS security improvements including CVE-2017-13704, CVE-2017-14106, CVE-2017-14491

Fixes:

- airMAX-ac FF: NBM5 lopsided signal strength fix
- Fix: Channel selection logic on XW after radar detection (sometimes data rate stuck at 54Mbps or channel width changes from 40MHz to 20MHz)
- Fix: Station TX power is set to 0dBm after disabling Automatic Power Control on AC AP (airMAX AC Mixed mode)
- Fix: Sometimes station stuck in association state
- Fix: SNMP get-next-request issue
- Fix: AP TX Power is set to 0dBm after disabling Automatic Power Control (PTP mode)
- Fix: Missing frequency ranges in airView for FCC SKUs

WEB UI:

- WEB UI: Indication next to TX Power that ATPC is enabled on AC AP (airMAX AC Mixed mode)

About Firmware Updates:

Applying a newer firmware version than the one already installed on your unit can bring various enhancements, include workarounds for diverse problems encountered by the device, and improve or add newly developed features.

On the other hand, downgrading the firmware version can recover the device’s functionality in the event of a software update either turning up faulty or causing the unit’s overall performance to drop. However, bear in mind that applying an older firmware isn’t recommended and might not always be possible.

When it comes to the update steps, due to the large variety of devices and numerous ways for installing a new firmware, it is recommended that you carefully read and understand the upgrade steps, and consider applying a different firmware only when you have familiarized yourself with the update method.

As the installation process is most of the times quite risky, this step should be taken by users that have the ability to successfully complete the update; regular users may initiate it at their own risk. Moreover, it’s best that this task be performed in a steady power environment such as the one ensured by a UPS unit.

Therefore, if you consider applying this release, hit the download button, take into account all the aforementioned aspects, and update the device’s firmware. Also make sure you constantly check with our website to ensure that you don’t miss a single new release.  

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Ubiquiti Drivers