Cisco RV325 Router Firmware 1.3.2.02 Download

Posted at April 29, 2024 by PCI-DB Team

Cisco RV325 Router Firmware 1.3.2.02 Description

New Features and Resolved Issues

New Features

Dongle Support has been added for the following:
- Pantech UML290 (Enhancement)
- D-Link DWM-157 C1
- Verizon U620L
- Huawei E3272 (Performance improved)
- Huawei E3276s-151

Resolved Issues

- iOS/MacOS built-in vpnclient can't connect with split-tunnel mode CSCuw30159)
- Performance hit after enabling SNMP (CSCva92155)
- VPN DNS Server1 always reverts to the router (CSCuy63266)
- Bandwidth Management page paritially displayed in Safari(CSCuy92246)
- Timeout settings not saved after reboot(CSCuy43470)
- 802.1x - PC connected to forced auth ports cannot access the network(CSCuw37974)
- VPN Status shows incorrect Easy VPN tunnels available(CSCuw32336)
- DDNS username won't allow more than 25 characters(CSCuv78522)
- Allow Policies showing in logs when are not enabled (CSCuw79932)
- Inter VLAN routing not working with 1:1 NAT(CSCuv74771)
- RV325 freezes and requires a reboot to recover(CSCut04694)
- Router stops working after ~24 hours when UPnP is enabled (CSCuz11504)
- Router crashes due to large packet header(CSCva91937)
- No DHCP offer when host name includes illegal character (CSCva92006)
- RV32x: Pantech UML290 can't get ip address(CSCuy81315)
- RV32x: PPE/PPC negotiation incompatibility
- RV32x: Security scan shows still affected by POODLE and DROWN

Installation Procedure:

- Save the downloadable package.
- Log into the router’s web user interface.
- Navigate to the firmware upgrade section of your wireless unit.
- Select the present firmware and configure your router to install this file.
- Wait as the device carries out this process.
- Reboot the unit if required.

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Cisco Drivers