Ubiquiti NSM2 Access Point Firmware 6.1.3.31939 Download

Posted at December 3, 2024 by PCI-DB Team

Ubiquiti NSM2 Access Point Firmware 6.1.3.31939 Description

New:

- New: TDD Framing/GPS Sync support for XM/TI devices
- New: UNMS agent upgrade to v0.1.0

Improvements:

- airMAX-ac FF: Performance and stability improvements
- AirOS stability improvements
- AirOS security improvements including CVE-2017-13704, CVE-2017-14106, CVE-2017-14491

Fixes:

- airMAX-ac FF: NBM5 lopsided signal strength fix
- Fix: Channel selection logic on XW after radar detection (sometimes data rate stuck at 54Mbps or channel width changes from 40MHz to 20MHz)
- Fix: Station TX power is set to 0dBm after disabling Automatic Power Control on AC AP (airMAX AC Mixed mode)
- Fix: Sometimes station stuck in association state
- Fix: SNMP get-next-request issue
- Fix: AP TX Power is set to 0dBm after disabling Automatic Power Control (PTP mode)
- Fix: Missing frequency ranges in airView for FCC SKUs

WEB UI:

- WEB UI: Indication next to TX Power that ATPC is enabled on AC AP (airMAX AC Mixed mode)

About Access Point Firmware:

If you update the Access Point (AP) firmware, your device can benefit from changes that fix multiple issues encountered by wireless clients, correct different user interface problems, add various functionalities, and include support for newly developed protocols.

Before performing this task, we recommend that you read and understand all the installation steps, because there are many AP models and manufacturers available. Each producer strives to make the procedure as simple as possible, but there are cases when it's anything but that.

It is also advisable that you apply a new access point firmware in a steady power environment (UPS unit will satisfy this need), using an Ethernet cable rather than a wireless connection. The latter can be easily interrupted.

With this in mind, if you wish to apply this version, click the download button and install the package on your access point. Remember to check back with our website as often as possible so that you don't miss a single new release.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Ubiquiti Drivers