Cisco RV130 Router Firmware 1.0.3.22 Download

Posted at November 24, 2024 by PCI-DB Team

Cisco RV130 Router Firmware 1.0.3.22 Description

New Features:

- USB Dongle Support Request: Huawei E3276 (CSCuz83436)

Issues Resolved:

- Some TCP traffic does not pass through IPsec Tunnel intermittently (CSCva49392)
- NAT drops randomly (CSCuz95671)
- VPN Site-to-Site can’t add remote network if 192.168.0.0 is used (CSCva91440)
- DHCP static page shows bland and Add button does not work (CSCca61922)
- user.err mDNSResponder: ERROR: getOptRdata - unknown opt 4 (CSCuy64987)
- Fail to Delete IPv4 ARP entry (CSCux99279)
- DHCP server hung up: Could not open raw socket (CSCuz82306)
- VPN fails if remote peer IP included in destination subnet (CSCuy29467)
- Feature request to disable UPnP by factory default (CSCvb14581)

Caveats Acknowledged in Firmware Version 1.0.3.16:

- Problem: GUI returns error when choose local VPN IKE ID as IP and remote ID as FQDN. (CSCux87754)
- Solution: Changing the local IKE ID types.

- Problem: Blacklist and whitelist in webfiltering should not be case sensitive. (CSCux72273)
- Solution: Input the lower case to the blacklist and whitelist.

Installation Procedure:

- Save the downloadable package.
- Log into the router’s web user interface.
- Navigate to the firmware upgrade section of your wireless unit.
- Select the present firmware and configure your router to install this file.
- Wait as the device carries out this process.
- Reboot the unit if required.

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Cisco Drivers