NETGEAR UTM9S Firewall Firmware 3.6.2-1 Download

Posted at November 2, 2024 by PCI-DB Team

NETGEAR UTM9S Firewall Firmware 3.6.2-1 Description

Fixes:

- Extended SSL VPN ActiveX certificate expiring.
- Fixed e-mails that were being sent by UTM were being marked as spam and the mail sender name "FROM" was being eradicated.
- Fixed the email does not work: when IMAP and IMAPS scanning is enabled, send email by Google mail from LAN host and receive email by Google mail does not always working.
- Fixed UTM does not work with ReadyNAS v 6.1.8.
- Fixed can't receive hotmail email when SMTP scanning enabled.
- Fixed the issue that IMAPS will stop working.
- Fixed Quarantine does not work issue.
- Fixed the SSL VPN access issue that different domain users can access each other portal.
- Fixed that users cannot disable Scanning Compatibility Mode.
- Fixed unable to load valid certificate to the UTM.
- Fixed that Wireless profile is disabled itself randomly.
- Fixed sometimes VPN IPSec connection cannot be re-established.
- Fixed the issue that when Protocol binding on WAN2 is configured, port-forwards on WAN1 does not work.
- Fixed customer cannot modify the entry in the LAN groups table.
- Fixed the issue that IPSec VPN tunnel will not be re-establish after reboot.
- Fixed the issue that L2TP connection cannot be established.
- Fixed the issue that PPTP VPN connection is disconnected after short time.
- Fixed the issue that inbound FW rules stop working.
- Fixed the issue that Customer cannot establish VPN client-to-box tunnel.
- Fixed the issue that for Dual WAN Load balancing mode, RDP, SMTP and HTTP cannot be established.
- Fixed the blank page issue when customer navigates to VPN->SSL VPN -->Policies page, selects a particular group.
- Fixed that the IPSec VPN pre-shared key turns into VPN Issues Asterisks after upgrading to a new image.
- Fixed the duplicate Firewall services issue when customer add a service, it shows two duplicate services.
- Fixed unable to load valid certificate to the UTM due to spaces issue.
- Fixed not PCI compliant issue.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers