NETGEAR GS748Tv4 Switch Firmware 5.4.2.13 Download

Posted at April 29, 2024 by PCI-DB Team

NETGEAR GS748Tv4 Switch Firmware 5.4.2.13 Description

New Features:

- EEE (IEEE802.3az)
- IPv4 Static Route.
- IPv6 ACL and QoS.

Fixes:

- CPU Notification Mode doesn't work
- LLDP not displaying correct values
- Switch forwards all traffic between Vlans during a reboot
- GS748Tv4 - Reboot randomly and unexpectedly
- RADIUS Assigned VLAN changes only when link goes down/up
- Duplicate SNMP V3 enginID cross many smart switches
- Cust_Esc: 802.1AS : CorrectionField has instabilities

Installation Instructions:

- Download and extract the new firmware to a convenient place such as your desktop. The filename after extracting is GS748Tv4_V5.4.2.13.stk
- Start Smartwizard Discovery Utility, (included on the CD coming with your Smart Switch). If it is not installed, do so before continuing.
- In Smartwizard Discovery window, click Discover to find your Smart Switch.
- The switch will be listed in the device list table once found.
- Highlight the Smart Switch to upgrade and click Firmware Upgrade.
- Follow the screen prompts to complete the upgrade. Smartwizard Discovery will report a successful completion at the end.

Note:

- Smartwizard Discovery uses broadcast packets to find Smart Switches, which means it can only find Smart Switches in the same routing domain.

Known Issues:

- The deny SNMP rule on management access control does not take effect.
- When EEE is configured with very low sampling-interval (like 30 sec) and cables are plugged in one after the other there is a rare chance of the box rebooting.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers