OCZ Vertex/Agility/Solid2 SSD Arowana Firmware 1.0.9 Download

Posted at November 5, 2024 by PCI-DB Team

Install Driver Automatically

Device Name	OCZ Vertex/Agility/Solid2 SSD Arowana Firmware 1.0.9
Category	Hdd Ssd Nas Usb Flash
Manufacturer	OCZ
File Size	5.1 MB
Supported OS	Windows XP ,Windows Vista ,Windows XP 64 bit ,Windows Vista 64 bit ,Windows 7 ,Windows 7 64 bit

OCZ Vertex/Agility/Solid2 SSD Arowana Firmware 1.0.9 Description

This update runs within Windows and you MUST have the SATA controller set to IDE, AHCI will cause it to fail. You will need another HDD connected to be running Windows from, you cannot update the drive Windows is running from.

This is a fully destructive update, your drive will be erased and then the new FTL will be flashed to the drive. Make a backup of anything on the drive that you need, there will be NO way back from this flash.

When the drive is successfully flashed you will see firmware version 3.55 after this update

This updater will only update drives that were shipped with specific Nand configurations. Those Nand configurations translate into the 6 digit "updater" number that can be viewed with OCZ SSD Identity Tool.

Notes:

1. The host system board must be set to IDE mode. If it is in AHCI mode the setting must be changed. Do not attempt to run this update if the IDE mode is not set. 
2. Backup all data on the drive before running this update. THIS UPDATE WILL DESTROY ALL DATA ON THE DRIVE.
3. Do not interrupt the update. An interruption may cause the drive to become unusable.
4. Do not run this update against a system boot drive.
5. The update may take up to 6 minutes to complete. Please be patient.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related OCZ Drivers