SanDisk SDSSDHP-128GB Ultra+ SSD Firmware X2316RL Download

Posted at December 22, 2024 by PCI-DB Team

SanDisk SDSSDHP-128GB Ultra+ SSD Firmware X2316RL Description

New changes since version X2306RL:

- Improved robustness of error handling and recovery
- Improved firmware download compatibility

New changes since version X211200:

- Enhanced UECC robustness in the event of an unexpected system power loss.
- Enhanced thermal throttling responsiveness under high temperature low power states.

SanDisk has released the ISO firmware images to allow SSD firmware update on operating systems that are NOT supported by the SanDisk SSD Toolkit. Each capacity drive has a separate Firmware ISO. You MUST use the correct firmware ISO for the capacity SSD you have installed.

WARNING:

- Applying the wrong firmware ISO to your SSD product will render the drive unusable!
- Please confirm the capacity of your SSD product before proceeding with the firmware download and update.

Note:

- The SanDisk Ultra+ SSD has two different model numbers. There is no functional difference between the two different model numbers. The Label on the SSD itself will always show SDSSDHP regardless of the internal model number.
- Please verify the model number.
- Do not use the SSD label to verify model number. Additionally you will need to know the capacity of your Ultra+ SSD and select the corresponding download.
- If the Firmware upgrade fails to install please check your BIOS SATA mode.
- If your computer's SATA mode is set to Legacy IDE please change the SATA mode to AHCI before performing the Firmware update.
- After the Firmware upgrade is complete log back in to the BIOS and change the SATA mode back to Legacy IDE

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Sandisk Drivers