NETGEAR XSM7224 Switch Firmware 11.0.0.12 Download

Posted at November 23, 2024 by PCI-DB Team

NETGEAR XSM7224 Switch Firmware 11.0.0.12 Description

Bug Fixes:

- Fixed the issue where 10G SFP+ port is unable to link up after switch reload with customer's config

Changes and Restrictions:

- If the network is configured as DHCP mode on the previous version, after it upgrades to 11.0.0.11, the "network" interface protocol mode will change to "none," and its IP will be set to "0.0.0.0" and DHCP mode is enabled on management VLAN instead.
- M7100 will not support IPv6 management if L3 license (routing and multicast) was not installed.
- The auto install is not allowed to apply a config file if the startup-config file contain the commands related to the "network" interface which is not supported on 11.0.0.11.
- If user configures the ports as protected port, routing mode is not allowed to configure on the VLAN in which those protected port are added.
- PVST/PVST+ M7100 only supports VLAN ID range from 1 to 1024. If user enables the PVST, make sure all of VLAN IDs are in the range of 1 to 1024.

About Switch Firmware:

Given the large variety of models and different methods for upgrading the switch, if you wish to apply this package, we recommend that you read and understand the installation steps before you install a new firmware, even if you are a power user.

Usually the update procedure isn’t much of a hassle as manufacturers try to make it as simple as possible; however, there are cases that are exceptions to this rule. First off, go to the system information page of the switch to check that the currently installed version isn’t either newer or matching this release.

Applying a new firmware can decrease the security vulnerabilities, enhance overall performance and compatibility, improve various power management functions, resolve different errors, and add support for newly developed technologies and protocols.

It is recommended that you perform this step in a steady power environment such as the one ensured by a UPS unit, and that you don’t interrupt the upgrade in any way, because this might cause the switch to malfunction.

That being said, click the download button, get and apply the new version, and check back with our website constantly to stay up to speed with the latest releases.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers