CradlePoint AER2100 Router Firmware 5.1.2 Download

Posted at December 22, 2024 by PCI-DB Team

CradlePoint AER2100 Router Firmware 5.1.2 Description

New features added in this release:

- Config difference CLI command: ‘diff’ from the command line will show any configuration items that are different than the default.
- ARP CLI command: ‘arpdump’ from the command line will dump the ARP table.
- (IBR6x0) Prepend System ID to GPS Sentences. System Settings -> Administration -> GPS -> Include System ID.
- (IBR6x0) Increase the maximum number of GRE tunnels from 5 to 10.
- Network Mobility (NEMO) changes to support failover. NEMO can be configured to operate with a specific WAN and will activate when a disconnection is detected from a primary WAN connection, or BGP or VRRP detect a peer failure.

Additional UI/Usability changes:

- Added a Red/Green indicator to the banner showing if the router is connected to ECM.
- For CradlePoint-based modems with supporting GPS, added ability to select between AUX and GPS ports to obtain coordinates

Defects fixed:

- NHRP with dual WAN connections does not come back up after a WAN failover
- SSH ‘cat’ command occasionally skips config portions
- Special Characters in System Identifier field can cause UDHCP to fail
- IBR600P/IBR650P only. Enabled SMS access for these devices
- Added data throttling to resolve a USB overrun situation that resulted in the router rebooting itself

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related CradlePoint Drivers