Ubiquiti USG Pro Access Point Firmware 4.3.60.5012144 Download

Posted at December 3, 2024 by PCI-DB Team

Ubiquiti USG Pro Access Point Firmware 4.3.60.5012144 Description

Changes since 4.3.49 release (previous release version) are as follows. 

- Implemented route metric changing on load-balance status changes. This fixes WAN failover issues with L3 adopted USGs, and improves multi-WAN failover functionality in general.
- Fixed multi-WAN regressions in 4.3.46-4.3.49 picked up from EdgeRouter 1.9.7.
- Implemented new local web UI on USG. Fixes a variety of long-standing bugs with the old UI, and adds ability to configure LAN IP and DHCP server.
- Updated ISC dhcp version. Looks to fix problems in some edge cases with multiple DHCP WANs and recovery after Ethernet link loss.
- Added back end for custom host-uniq for PPPoE.
- Fixes for some uses of multiple routing tables (nothing controller-provisioned does anything impacted by this, a small number use config.gateway.json VPN configurations which do)

About Access Point Firmware:

If you update the Access Point (AP) firmware, your device can benefit from changes that fix multiple issues encountered by wireless clients, correct different user interface problems, add various functionalities, and include support for newly developed protocols.

Before performing this task, we recommend that you read and understand all the installation steps, because there are many AP models and manufacturers available. Each producer strives to make the procedure as simple as possible, but there are cases when it's anything but that.

It is also advisable that you apply a new access point firmware in a steady power environment (UPS unit will satisfy this need), using an Ethernet cable rather than a wireless connection. The latter can be easily interrupted.

With this in mind, if you wish to apply this version, click the download button and install the package on your access point. Remember to check back with our website as often as possible so that you don't miss a single new release.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Ubiquiti Drivers