NETGEAR GS105E Switch Firmware 1.01.25 Download

Posted at November 21, 2024 by PCI-DB Team

NETGEAR GS105E Switch Firmware 1.01.25 Description

New Features and Changes:

- Add a new option “any” to IGMP Snooping Static Router Port selection (System > MultiCast > IGMP Snooping). When selected, IGMP control packets are flooded to all ports.
- Increase the DHCP timeout time from 15 seconds to 60 seconds

Modifications / Fixes:

- Fix the issue when IGMP Snooping and Block Unknown Multicast Address (System > MultiCast > IGMP Snooping) are disabled, the following multicast MAC addresses are not being forwarded: 01:00:5E:00:00:01, 01:00:5E:00:00:02 and 01:00:5E:00:00:16.
- Fix the issue when port-based VLAN is enabled, multicast packets with destination IP 01:00:5E:00:00:03 to 01:00:5E:00:00:FF and 01:005E:7F:FF:FA are flooded across all VLANs.
- Fix the issue that incoming VLAN Tagged packets with the following destination MAC addresses are forwarded out even when the receiving port is not in the same VLAN group as the VLAN Tag: 01:00:5E:00:00:03 to 01:00:5E:00:00:0F and 01:00:5E:7F:FF:FA.
- Fix the issue when Block Unknown Multicast Address (System > MultiCast > IGMP Snooping) is enabled, packets with the following destination MAC are blocked: 01:80:C2:00:00:00 ~ 01:80:C2:00:00:0F.

Installation Instructions

- Download the new firmware to a convenient place on your local system and extract the ZIP file
- Start ProSafe Plus Configuration Utility
- The ProSafe Plus Utility will scan and detect ProSafe Plus switches on your network. Select the switch to upgrade by clicking on the radio button next to the switch. Enter the administrator password of the switch when prompted.
- Select Maintenance under the System tab. Click on Firmware Upgrade and Browse to the location when the firmware image is saved
- Click Apply to start firmware upgrade

About Switch Firmware:

Given the large variety of models and different methods for upgrading the switch, if you wish to apply this package, we recommend that you read and understand the installation steps before you install a new firmware, even if you are a power user.

Usually the update procedure isn’t much of a hassle as manufacturers try to make it as simple as possible; however, there are cases that are exceptions to this rule. First off, go to the system information page of the switch to check that the currently installed version isn’t either newer or matching this release.

Applying a new firmware can decrease the security vulnerabilities, enhance overall performance and compatibility, improve various power management functions, resolve different errors, and add support for newly developed technologies and protocols.

It is recommended that you perform this step in a steady power environment such as the one ensured by a UPS unit, and that you don’t interrupt the upgrade in any way, because this might cause the switch to malfunction.

That being said, click the download button, get and apply the new version, and check back with our website constantly to stay up to speed with the latest releases.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers