NETGEAR WNDAP350 Access Point Firmware 3.7.4.0 Download

Posted at December 3, 2024 by PCI-DB Team

NETGEAR WNDAP350 Access Point Firmware 3.7.4.0 Description

Bug Fixes:

- Fixed firmware upgrade related security vulnerabilities
- More channels are available to configure when APs are managed through Business Central.
- Fixed issues related to displaying AP uptime under the Monitoring -> System GUI page
- Fixed issue where AP is not accessible whenever all the wireless client associated to the Dynamic VLAN enable SSID got disconnected
- Fixed few AP random reboot issues after long run when APs are managed through Business Central.
- Fixed RADIUS failover issue when the primary RADIUS authentication server is not reachable
- Fixed intermittent data path issues with Samsung mobiles.

Known issues:

- Rogue AP detection table may not list all the neighbor APs immediately
- Time not updated properly in the AP GUI for the time zone Georgia.
- AP reboot required after changing the authentication from WEP to WPA/WPA2-PSK only when WDS is enabled for 2.4GHz and 5GHz radio simultaneously
- Sometimes GUI page takes long time to load when moving between the tabs multiple times and after FW upgrade. Workaround: Refresh the browser page where the page loads immediately.

To Install:

- Download the new software and save it to a convenient folder location.
- Login to the access point web management GUI.
- Take backup of the current configuration and save it at a secure place.
- Select Maintenance > Upgrade > Firmware Upgrade.
- Click Browse and browse to the location of the software upgrade file that you just downloaded.
- Click Apply. The upgrade process typically takes at least 8 minutes.
- Warning: When uploading software to the Wireless Access Point, it is important not to interrupt the Web browser by closing the window, clicking a link, or loading a new page. If the browser is interrupted, the upload might fail, corrupt the software, and render the access point completely inoperable.
- When the upload is completed, your wireless access point automatically restarts.
- If you decide to use the AP as standalone, log into the AP and disable Cloud management.
- If you decide to use the AP in cloud management, factory reset the AP and add the AP to BCWM portal 

About Access Point Firmware:

If you update the Access Point (AP) firmware, your device can benefit from changes that fix multiple issues encountered by wireless clients, correct different user interface problems, add various functionalities, and include support for newly developed protocols.

Before performing this task, we recommend that you read and understand all the installation steps, because there are many AP models and manufacturers available. Each producer strives to make the procedure as simple as possible, but there are cases when it's anything but that.

It is also advisable that you apply a new access point firmware in a steady power environment (UPS unit will satisfy this need), using an Ethernet cable rather than a wireless connection. The latter can be easily interrupted.

With this in mind, if you wish to apply this version, click the download button and install the package on your access point. Remember to check back with our website as often as possible so that you don't miss a single new release.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers