NETGEAR DGN1000v3 Router Firmware 1.0.0.22 Download

Posted at December 19, 2024 by PCI-DB Team

NETGEAR DGN1000v3 Router Firmware 1.0.0.22 Description

Bug Fixes:

- Fixed SOAP security issue
- Fixed the SSL POODLE vulnerability issue
- Modified the WANIPConnection::GetInfo SOAP API to return the default MAC address even on PPPoA
- Corrected the parental control for PPPoA connection type
- Fixed the issue where NETGEAR Genie show “The operation timed out” issue
- Fixed the issue where router blocks the inbound traffic from WAN when it’s set as pure router mode (NAT disabled)
- Corrected the debuginfo page error when connection type is PPPoA

Known Issues:

- The Windows/MAC Genie application will scan devices (by sending ARP packets) and update the network map automatically. It will cause some wireless devices show as wired connection type for a while (until the application update the network map from the router).
- Sometimes the attached devices feature cannot get some wireless devices. (It caused by ARP packet loss).

To Upgrade:

- Download and extract the new firmware to a convenient place such as your desktop. The filename after extracting is DGN1000v3-V1.0.0.20_0.0.20.img
- Using a web browser, login to the router as admin.
- Under Maintenance click Router Upgrade.
- Click Browse and locate the upgrade file DGN1000v3-V1.0.0.14_0.0.14.img.
- Click Upload.
- Wait for the upgrade progress bar to complete and final prompt to appear.
- If problems occur after upgrading, try clearing the configuration by pressing the Factory Defaults pushbutton on the rear panel until the Test LED blinks (about 5 seconds). Then reenter your configuration information manually

Note:

- To avoid wireless disconnect issue during the firmware download process, NETGEAR recommends that firmware upgrade be performed on a computer with wired connection.

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers