Ubiquiti UAP-AC-M-PRO Access Point Firmware 3.8.6.6650 Download

Posted at November 21, 2024 by PCI-DB Team

Ubiquiti UAP-AC-M-PRO Access Point Firmware 3.8.6.6650 Description

Changes:

- [UAPG3] Fix MAC ACL and blocking support.
- [AC-IW/Pro/EDU/M-Pro] Fix a bug with egress QoS.
- [AC-IW/Pro/EDU/M-Pro] Improve address resolution logic (ARL) caching support.
- [AC-IW/Pro/EDU/M-Pro] Add STP state and uptime.
- [AC-IW/Pro/EDU/M-Pro] Improvement to fix topology view.
- [UAP] Add backend for 802.1X MAC authentication bypass support.
- [UAP] Add Framed-IP-Address to RADIUS accounting data.
- [UAP] Add NAS-IP-Address to RADIUS data.
- [UAP] Various backend fixes.
- [USL2] Add support for switch power monitor and PSU info.
- [USW] Fix DoS issue reported via HackerOne program.
- [USW] Add per port Class of Service (CoS) queuing and max traffic class support.
- [USW] Delay port LED blinking until system ready.
- [USW] Add backend for 802.1X MAC authentication bypass support.
- [USW] Add support for port egress rate limiting.
- [HW] Fix issue with curl config, so FTP firmware upgrades work again.
- [HW] Backend optimization to save some space.

About Access Point Firmware:

If you update the Access Point (AP) firmware, your device can benefit from changes that fix multiple issues encountered by wireless clients, correct different user interface problems, add various functionalities, and include support for newly developed protocols.

Before performing this task, we recommend that you read and understand all the installation steps, because there are many AP models and manufacturers available. Each producer strives to make the procedure as simple as possible, but there are cases when it's anything but that.

It is also advisable that you apply a new access point firmware in a steady power environment (UPS unit will satisfy this need), using an Ethernet cable rather than a wireless connection. The latter can be easily interrupted.

With this in mind, if you wish to apply this version, click the download button and install the package on your access point. Remember to check back with our website as often as possible so that you don't miss a single new release.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Ubiquiti Drivers