ZyXEL GS2200-8HP Switch Firmware 4.00(AAAW.3)C0 Download

Posted at November 23, 2024 by PCI-DB Team

Install Driver Automatically

Device Name	ZyXEL GS2200-8HP Switch Firmware 4.00(AAAW.3)C0
Category	Router Switch Access Point
Manufacturer	Zyxel
File Size	2.3 MB
Supported OS	OS Independent

ZyXEL GS2200-8HP Switch Firmware 4.00(AAAW.3)C0 Description

Fixes:
- When the switch is in the default config, if we set the service-control http 23 30, the DUT will crash since command parsed error.
- When using SNMPc to view the dot1agCfmMepDbTable (OID: 1.3.111.2.802.1.1.8.1.7.3), DUT will crash
- When uploading firmware using ftp from in-band, and write memory 1 at the same time, DUT will crash.
- When send error packet to DUT, we cannot see error count at UI(Web, CLI) after link down this port.
- Memory leak due to send fault trap but not free.
- IP mac move will cause the Ping process fail when linking to two devices with same IP and MAC.
- Disable arp-learning mode but DUT disable wrong port
- In spanning tree + static trunk environment, the host’s mac will be learned to wrong port.
- In Web, when set Queues weight over range, the warning message is incorrect.
- In Web, when setting MRSTP port path cost to invalid value, the error message shows error
- When igmp-snooping querier is disabled, if the DUT receives a general query with smaller IP than DUT, DUT will periodicity sends out general query after DUT's querier port timeout.
- In web set subnet-based VLAN entry with multicast or reserved IP address, write memory, restore config, DUT pop error message.
- Device crash when backup huge configuration to TFTP server via SSH version 1
- Doing fiber port link down/up overnight test, DUT crash
- When system log is full, every newly add log will add a table full log into errlog.
- Switch does not do mac move in arp-request mode.
- Power off when system is booting and then reboot the system, will put all port into inactive status in show running and the user config dispear.
- ALARM LED cannot keep turn ON after HTP burn in test is failed.
- If the management address type of remote machine is ipv6, management address of "show lldp info remote interface port-channel" will be abnormal format (mac-address format)
- Clear some warning on .mib for MIB management tool of what’s up
- ITS (UK): GS2200-24 stop forwarding multicast traffic and loss of management, also the console no response.
- [Web] ARP table’s item will display error when user using web arp table’s port flush
- [ipv6] upload the wrong firmware version (upload GS2200-24P’s firmware to GS2200-8HP) will cause DUT crash
- [Auto]When run the automation scipt, DUT will crash.
- Fix “show tech-support” hang
- DUT sends two or more different LLDP packets on the same port.
- Normal reboot (warm start) will clear the stack information of crash in the debug area
- [Web] User cannot access the error.html when configuration is wrong via ipv6 link-local address on Windows XP.
- [Web] User cannot upgrade firmware via ipv6 link-local address on Windows XP and will cause huge memory leak in this environment

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Zyxel Drivers