NETGEAR FVS318N Firewall Firmware 4.1.1-8 Download

Posted at May 31, 2025 by PCI-DB Team

NETGEAR FVS318N Firewall Firmware 4.1.1-8 Description

New features:

- IPv6 Firewall support.
- IPv6 Prefix Delegation.
- IPv6 IPSEC and SSL VPN.
- Multiple SSID for wireless.
- CLI support.

Bug Fixes:

- Loopback does not work for DMZ LAN.
- When you click the Auto detect button on the WAN Settings page, you cannot connect to the internet for more than 7 minutes.
- Cannot establish a tunnel using Radius-PAP authentication.
- Ping using Diagnostic tool in GUI fails over anipv6 IPSec tunnel.
- Sometimes synchronization takes too long.
- Cannot configure FQDN in the 'Add New VPN Policy' page.
- The DMZ WAN cannot connect after adding a route.
- You cannot configure an IPSec "client to gateway" vpn that uses an IPv6 address in the VPN Wizard page.
- You cannot add the customer vlan when its DHCP server is disabled and you cannot disable the DHCP server of the default vlan.
- Unit shows a critical error when packets are captured.
- Cannot configure a LAN DHCP relay.
- Forwarding performance is improved.
- GUI response is Improved.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers