NETGEAR R7800 Router Firmware 1.0.2.12 Download

Posted at November 2, 2024 by PCI-DB Team

NETGEAR R7800 Router Firmware 1.0.2.12 Description

New Features and Enhancements:

- Added WiFi 5G band support for FCC DFS channels 52, 56, 60, 64, 100, 104, 108, 112, 116, 120, 124, 128, 132, 136, 140.
- Upgraded OpenSSL cryptography library from V1.0.0 to v1.0.2h.

Bug Fixes:

- Fixes security issue in which TCP port 80 and port 443 were always opened in IPv6 environment.
- Fixes security issue in which remote management interface still could be accessed even if it was disabled when the request packet is using 1723 as source port.
- Fixes security issue in which R7800 reboots when using $(reboot) as user name to register ReadyCLOUD.
- Fixes the issue in which the flash drive connected to USB port2 cannot be added into approved USB devices list.
- Fixes the issue in which the desktop genie was unable to access R7800 remotely.
- Fixed other minor bug fixes.

Known Issues:

- Intel 7260/3160 has a connection problem with the R7800 when the HT160 is enabled. This issue is due to the Intel driver. Intel is looking into this.

Installation steps:

1. Write down all the settings that were changed from the default values as you may need to re-enter them manually.
2. Download firmware file and extract the new firmware to a convenient place such as your desktop. 
3. To log in to the router type http://www.routerlogin.net into your web browser address bar (such as Internet Explorer or Google Chrome).
4. Click ADVANCED tab > Administration > Firmware Upgrade.
5. Click Browse and find the file you just downloaded.
6. Click Upload. Do not interrupt the upgrade during this step.

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers