Ubiquiti AR-HP Router Firmware 6.0.6.31296 Download

Posted at September 28, 2024 by PCI-DB Team

Ubiquiti AR-HP Router Firmware 6.0.6.31296 Description

New:

- Signed firmware support
- Upgrade libpcap to 1.8.1
- Additional statistics for AC2 agent

Improvements:

- NanoStation Loco model name changed to NanoStation loco
- airOS security and stability improvements

Regulatory updates:

- Updated 2GHz frequency list: removed 2464MHz for FCC and 2474MHz for EU
- Added 40 MHz channel width for Saudi Arabia

Fixes:

- Fix: AP/Station canâ€t reconnect after changing SSID and Security
- Fix: Make CoS values priority on by default on bridge with VLAN ports
- Fix: Firewall IPv4 and IPv6 both enabled on bridge link don't work
- Fix: Show DHCP client hostname in DHCP Leases in case hostname contains special symbols
- Fix: Revert Device Name strictness for DHCP Client (escape only hashtag '#' symbol which breaks DHCP Client operation)
- Fix: AMC and AMQ are reporting far too high for 1x1 chain XM clients in 2AC Mixed mode
- Fix: Issues with channel width selection on Wireless tab after reset to default and upgrade for M365 models
- Fix: Invalid channel width selection for Japan when changing wireless mode from Station to AP
- Fix: RADIUS Accounting fixes: duplicated Acct-Session-Id, incorrect Acct-Input-Octets and Acct-Output-Octets values
- Fix: Missing statistics for AC2 agent if PPPoE interface is configured on Wireless interface
- Fix: syslogd crash when remote TCP log is enabled

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn't either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn't be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don't always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you're looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don't power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don't miss the update that will improve your device.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Ubiquiti Drivers