Cisco 6945 IP Phone Firmware 9.4.1.3 Download

Posted at December 25, 2024 by PCI-DB Team

Cisco 6945 IP Phone Firmware 9.4.1.3 Description

Fixes:

- 69xx phones non standard Not Enough Bandwidth message absent
- "Not enough bandwidth" message shown on 69xx phones after call ends
- 6921 SiP: phone freeze when clear status message
- Default ringtones for 6961 phones not working in version 9-2-1-0
- 69xx phones display "call ended" after services message is sent
- 6941 Unable to disable corporate directory
- Reset network configuration and set Admin Vlan it does not take effect
- 69XX unable to show conference details
- 6941 / 6961 phones may freeze after many successive calls
- RTPRx sent to 6941 phone, but no sound is heard
- CME 6961 - Cannot Tell Which Line has Message Waiting
- 69XX phone fails to play Multicast MoH, user hears Tone on Hold instead
- Service menu down when Publisher goes down - 6941
- Phone go to SRST when DNS server down and no ipv6 address
- 69XX Hebrew words/characters are reversed when XML is parsed
- EM does not work with service provisioning set to both
- CiscoIPPhoneInput backspace key broken if URL is longer than 171 characters
- The Digit dialed when an incoming number pops up are ignored
- Apply TX limiter to limit sending peak level under PSTN Mode
- CP-6921 RTPMTx sets TTL of sent multicast packets to 1
- Blind Transfer caused the line to "lock up" on phone
- 69xx phones non standard Not Enough Bandwidth message absent
- 6961 Active call timer resets to 0 in shared line configuration-the active call timer may reset
- 6961 freezes after many successive calls to it while a call is on hold
- Hold button stops working on 6961
- Switching from speaker to handset doesn't work on 6961
- Going off hook activates new call on idle line instead of answering call
- 6921 will not go into SRST if default GW is set as SRST reference in DP
- Unable to dial external phone numbers from their personal directory

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Cisco Drivers