Snom 320 IP Phone Firmware 7.3.30 Download

Posted at June 3, 2024 by PCI-DB Team

Snom 320 IP Phone Firmware 7.3.30 Description

Fixes:

- Added new setting transfer_on_hangup_with_starcode to allow transferring calls on hangup if one call was picked up with PBX starcode. 
- Clean paint area for title (snom370).
- Codec type and TX-RX stats could not be displayed anymore during call at the display.
- Don't handle key event F_LOGOFF_ALL if a line is connected or on hold.
- Don't resend ring command if phone is already ringing even if there is more than one incoming call. 
- Handle action of FKeys only if state isn't mini browser state. 
- Setting Use Speaker Key to Receive Calls is valid for headset key too now. 
- Show LDAP result instead of display name if setting prioritise_pbx_number_lookup is off.
- Send VQ-Report for hanging up on a holding line as well.
- Make re-register after check-sync if necessary. 
- Un-REGISTER sets unregistered identity to inactive.
- Termination of Registration/Subscription initiated by check-sync notify works now.
- Some setting changes were effecting other settings even though they were not changed by the user.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Snom Drivers