NETGEAR GS728TS Switch Firmware 5.3.0.31 Download

Posted at April 17, 2025 by PCI-DB Team

NETGEAR GS728TS Switch Firmware 5.3.0.31 Description

Bug Fixes:

- Multicast packet with destination MAC address of 01:80:c2:00:00:1c and Ethernet type of 0x88CC causes loop in properly converged STP topology.
- Debugging URL of ‘devshell’ is accessible without authentication.
- Fiber port 50 goes down when copper port47/port48 links up.
- Cannot access switch via HTTPS when using the certificate generated by the switch.

Upgrade Procedure:

- Download the new firmware, store it in local PC, and remember its location in the PC’s file system.
- Unzip it to get the switch image.
- Go to GUI page “Maintenance > File Management > Dual Image > Dual Image Configuration”, find the backup (next-active) image.
- Support the backup-image is image1, then go to “Maintenance > Download > HTTP File Download”, set File Type as ‘Archive’, set Image Name as ‘Image1’, select the firmware file stored in local PC via Browser button, then click Apply button to start firmware downloading.
- The download will take several minutes. Do not power cycle the switch before and the success message shows up as below.
- Go to GUI page “Maintenance > File Management > Dual Image > Dual Image Configuration”, set ‘Unit Number’ as ‘All’; set ‘Image Name’ with Image1; check the checkbox of ‘Activate Image’, then Apply.
- Go to GUI page “Maintenance > File Management > Dual Image > Dual Image Status”, to double check the firmware version is correctly downloaded to image1 and image1 is the ‘next-active’ image. If not, go back to step 3 to download the switch image again.
- Go to GUI page ‘Maintenance > Reset > Device Reboot’, set ‘Reboot Unit No.’ as ‘All’ (default option); check the checkbox then click Apply button.
- After the switch is restarted, login the switch to double check whether the FW is upgraded correctly, via GUI page of “GUI page System > Management > System Information”.

About Switch Firmware:

Given the large variety of models and different methods for upgrading the switch, if you wish to apply this package, we recommend that you read and understand the installation steps before you install a new firmware, even if you are a power user.
Usually the update procedure isn’t much of a hassle as manufacturers try to make it as simple as possible; however, there are cases that are exceptions to this rule. First off, go to the system information page of the switch to check that the currently installed version isn’t either newer or matching this release.

Applying a new firmware can decrease the security vulnerabilities, enhance overall performance and compatibility, improve various power management functions, resolve different errors, and add support for newly developed technologies and protocols.

It is recommended that you perform this step in a steady power environment such as the one ensured by a UPS unit, and that you don’t interrupt the upgrade in any way, because this might cause the switch to malfunction.

That being said, click the download button, get and apply the new version, and check back with our website constantly to stay up to speed with the latest releases.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers