Ubiquiti UAP-OD Access Point Firmware 3.7.39.6089 Download

Posted at December 23, 2024 by PCI-DB Team

Ubiquiti UAP-OD Access Point Firmware 3.7.39.6089 Description

Changes:

- [UAP] Prevent VAPs with a bad config from coming up open. 
- [UAPG3] Enable MU-MIMO sounding.
- [UAPG3] Advertise country information element.
- [UAPG3] Advertise QBSS Load information element.
- [UAPG3] Update powersave function.
- [UAPG3] PN replay improvements.
- [UAP] Enable DHCP broadcast to unicast conversion by default.
- [USW] Improve device logging
- [USW] Add missing FASTPATH command to clear MAC address table (non-XG models).

About Access Point Firmware:

If you update the Access Point (AP) firmware, your device can benefit from changes that fix multiple issues encountered by wireless clients, correct different user interface problems, add various functionalities, and include support for newly developed protocols.

Before performing this task, we recommend that you read and understand all the installation steps, because there are many AP models and manufacturers available. Each producer strives to make the procedure as simple as possible, but there are cases when it’s anything but that.

It is also advisable that you apply a new access point firmware in a steady power environment (UPS unit will satisfy this need), using an Ethernet cable rather than a wireless connection. The latter can be easily interrupted.

With this in mind, if you wish to apply this version, click the download button and install the package on your access point. Remember to check back with our website as often as possible so that you don’t miss a single new release.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Ubiquiti Drivers