NETGEAR R6300v2 Router Firmware 1.0.3.26 Download

Posted at December 22, 2024 by PCI-DB Team

NETGEAR R6300v2 Router Firmware 1.0.3.26 Description

New Features & Enhancements:

- Adds a new setting to the “LED Control Settings” page in which the NETGEAR logo LED can be tuned on and off.
- Improves the auto channel selection algorithm.
- The port forwarding rule supports the "different external port but same internal port for different internal IP."
- DLNA scans when a USB storage device is configured as "all-no password" for the read access and as "admin” for the write access.

Bug Fixes:

- Fixes the issue in which the router cannot recognize HFS file system larger than 2TB.
- Fixes the synchronization issue that the NTP server has with some Thomson modems.
- Fixes the issue in which the 5 GHz WiFi radio stops working when the router is configured in AP mode and the WiFi on and off schedule is configured.
- Fixes some interoperability issues with the QNAP NAS.
- Fixes the issue in which the router cannot get an IPv6 address after disabling and then enabling PPPoEv6.
- Fixes the issue in which the router incorrectly reserves port 1194 when no OpenVPN service is enabled.
- Fixes the issue in which the "Attached device" page show only one device when there are multiple IP's assigned to the same MAC address.
- Fixes the issue in which when IPv6 is enabled, the LAN PC cannot ping or access ipv6.google.com when IPv4 on the LAN PC is disabled and the LAN PC is rebooted.
- Fixes the issue in which the 2.4 GHz SSID cannot be detected after disabling both 5GHz and 2.4GHz and then enabling the 2.4 GHz WiFi radio only.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers