NETGEAR GSM7252PS Switch Firmware 10.0.0.53 Download

Posted at December 22, 2024 by PCI-DB Team

NETGEAR GSM7252PS Switch Firmware 10.0.0.53 Description

Bug Fixes from Release 10.0.0.44:

- Unable to enable routing on VLAN 1 from GUI
- SNTP synchronized time is truncated, when show sysinfo by CLI
- Stop offering IP address when there are many DHCP IP conflicts in DHCP pool
- Switch crashed when issue 'Show vlan private-vlan'
- All of ports became 'detach' after remove one rule in ACL
- M5300-28/52G-POE+ cannot provide power to PD with RPS5412
- Switch keep printing Power Supply Alarm& Alerts with RPS5412 in specific scenario
- Connection via AX745 didn't not come UP after switch rebooted
- Unable to upload license if license name contains invalid character
- Unable to configure DHCP pool option 42
- Should not allow switch to create a script name with space
- Command {deny | permit} (IPACL) does not have rule(order) ID
- Can't block switch's TFTP service via Management ACL
- Cannot change AUTO VoIP VLAN ID 2 to other VLAN ID
- Increase the characters usable for the username e-mail alert
- Static network address is reset as soon as change the ip address on interface from none to DHCP mode
- The port numbers are missing at the bottom on device view
- M5300 rebooted after enable TLS for email alert
- LED of fiber port remains light up after fiber is removed
- GUI response is very slow and unstable when https is enabled
- Memory leak when walked on IfMib counters
- When a RPS5412 is plugged into a live switch (already powered up), PD device may not get power
- Switch might crash when autoVOIP and Voice VLAN are used at the same time

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers