PCI-DB.com
  1. Driver
  2. Firmware
  3. HP Seagate Barracuda 7200.11 Firmware HP13 Rev.A

HP Seagate Barracuda 7200.11 Firmware HP13 Rev.A Download

Posted at December 18, 2024 by PCI-DB Team

Install Driver Automatically
Device NameHP Seagate Barracuda 7200.11 Firmware HP13 Rev.A
CategoryFirmware
ManufacturerSeagate
File Size1 MB
Supported OSWindows All

HP Seagate Barracuda 7200.11 Firmware HP13 Rev.A Description

This package contains a firmware upgrade for the Seagate ST3500620AS Hard Drives installed in the supported desktop and workstation models that are running a supported operating system.

NOTE:

This package includes a utility that checks to ensure that an affected hard drive model is installed before upgrading the firmware.  If the correct hard drive model is not found the firmware is not upgraded.
FIXES:
- Corrects an issue where the hard drive cannot communicate with the computer immediately following a power cycle (system is powered off and then powered back on).

PREREQUISITES:

- The firmware update utility cannot upgrade drives that are members of RAID arrays. However, it is possible to temporarily take the system out of RAID mode, perform the upgrade on the target drives, and then put the system back into RAID mode. Because the firmware upgrade does not affect the data contents of the drives, including their RAID membership data, the array will operate normally when the RAID mode is restored. In all the supported desktop and workstation models for this update, the SATA controller mode can be managed via options in the BIOS F10 Setup interface. For specific instructions, see the manual for your computer model. This mode management does NOT involve deleting or creating RAID arrays.

- DOS Bootable Media.

- An HP Seagate ST3500620AS Hard Drive model must be installed in the system.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Seagate Drivers

HP Seagate Cheetah SAS Hard Drive Firmware HPS4 Rev.A

Device Type: Firmware File Size: 1.3 MB Windows XP ,Windows Vista ,Windows XP 64 bit ,Windows Vista 64 bit

Install Driver

Seagate SATA HDD Firmware HP2A Rev.A

Device Type: Firmware File Size: 4.4 MB Windows All

Install Driver

Find Missing Drivers

© 2024 PCI-DB.com - PCI Database Replacement. All rights reserved.