Ubiquiti UVC IP Camera Firmware 3.4.0 Download

Posted at December 22, 2024 by PCI-DB Team

Ubiquiti UVC IP Camera Firmware 3.4.0 Description

Change Log:

- Cameras: Motion detection improvements for G3 cameras
- Cameras: Fixed an issue where Lens Distortion Correction setting would reset on camera reboots.
- Cameras: Fixed an issue causing IR to malfunction when changing between modes
- Cameras: Add support for anonymous snapshots
- Cameras: Fixed a memory leak tied to changing time zones
- Cameras: UVC Pros are now capped at 25 fps, this is due to Pros not recording properly at 30fps due to resource limitations.
- Cameras: Gateway and DNS are no longer mandatory when setting a static IP on the camera
- Camera: Fixed an issue timezone will set to GMT when login into camera standalone web UI
- Camera: Fixed an issue camera timezone doesn't sync with controller
- Web UI: Added distortion correction setting for G3 cameras
- Web UI: Added image enhancement mode toggle (i.e. Magic Zoom) for G3 cameras

Known Issues:

- When inviting other users to access your NVR via the cloud, if they've never registered with Ubiquiti before, they'll need to confirm their account (in a separate email).
- Timeline only works on recordings made with UniFi Video 3.2+. It will not show recordings made with 3.1.x.
- UVC Pros have issues at higher FPS, for accurate recordings, use 25FPS.

About Network Camera Firmware Updates:

Updating to a newer firmware version than the one already installed on your network camera can improve the device’s overall performance and stability, resolve various issues, and add support for newly developed features or enhance existing ones.

On the other hand, downgrading the camera’s firmware can recover its functionality in the unlikely event the currently installed version is faulty, or the device’s performance dropped after an upgrade. However, bear in mind that applying an earlier build might not always be possible.

Changing the camera’s firmware must be performed when the new release resolves an issue that your device has encountered or adds a new feature (or enhances an existing one) that could prove useful to you.

As for the installation method, the steps vary depending on the model you own, but basically, you must connect your camera via an Ethernet cable (username and password required), and use the downloadable file in the Firmware Update section to upgrade your device. Make sure you do not interrupt the installation process.

However, make sure you carefully read and understand the installation steps so that you don’t end up with a broken device. This process isn’t intended to be destructive, but still, it’s best to save all configurations before applying a different firmware.

That being said, if you consider that this firmware improves your device in any way, then hit the download button and get the desired version; if not, check our website as often as possible so that you don’t miss the update that will boost your camera’s performance. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Ubiquiti Drivers