NETGEAR WNDAP350 Access Point Firmware 2.1.8 Download

Posted at December 25, 2024 by PCI-DB Team

NETGEAR WNDAP350 Access Point Firmware 2.1.8 Description

Fixes:

- Fixed the issue that carrier interference not getting detected in 5 GHz.
- Fixed the ping loss issue observed on M3 Mobile PDA.
- Added dynamic VLAN support.
- Added 2.4 GHz carrier sense fix.
- Changed the behavior such that if the serial number of the AP is already registered, do not contact the registration server again on clicking every configuration page.
- Fixed the problem that access to GUI pages is slow when DNS server is not resolved
- Fixed the issue that beacons are not getting updated properly when Rogue AP is enabled. This is causing throughput inconsistencies and packet loss when Rogue AP is enabled.
- Fixed problem that if wrong DNS Server addresses is configured, AP is unable to get response.
- Added IGMP Snooping support.
- Fixed the packet loss issue when Rogue AP detection is enabled.
- Fixed the problem when client connected to each band, but it only shows 2.4GHz band.
- Fixed the security issue where user is able to log-in without username & password.
- Changed to code to support CE Adaptivity.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers