Ubiquiti NSM365 Access Point Firmware 6.1.7.32555 Download

Posted at December 27, 2024 by PCI-DB Team

Ubiquiti NSM365 Access Point Firmware 6.1.7.32555 Description

New:

- New: Support for the new TDD Framing Flexible (NEW) mode (airMAX AC AP on v8.5.4 required)
- New: TDD Framing/GPS Sync support for 10MHz in AP PtMP airMAX Mixed mode (airMAX AC AP on v8.5.4 required)
- New: IPV6 addresses support in the Ping tool
- New: Daylight Saving Time support
- New: ULink, UNMS, UCRM icons on Login page
- New: UNMS agent upgrade to v0.3.12
- New: Updated EULA and Privacy Policy agreements

Regulatory updates:

- Updated New Zealand allowed frequencies for 5GHz

Improvements:

- airOS stability improvements

Fixes:

- Fix: Allow configuring local or static IPv6 address on LAN even IPv6 is not set on WAN
- Fix: Need restart dnsmasq service after IPV6 gets DNS from DHCP
- Fix: Make DHCPv6 Unique Identifier (DUID-UUID) permanent
- Fix: DNS configuration when DHCP on WAN is selected
- Fix: No internet access for LAN clients with specific DHCP server and DNS proxy configurations (router mode)
- Fix: Wrong airMAX Quality reporting of 1x1 chain devices
- Fix: Station cannot connect to 40MHz AP for New Zealand country
- Fix: Reduce IPv6 server and client syslog messages

WEB UI:

- WEB UI: Remote stats are missing in case "Extra reporting" is enabled but related cfg key is missing
- WEB UI: airMAX Capacity reporting issue in VHT10 mode
- WEB UI: Various small UI improvements

About Access Point Firmware:

If you update the Access Point (AP) firmware, your device can benefit from changes that fix multiple issues encountered by wireless clients, correct different user interface problems, add various functionalities, and include support for newly developed protocols.

Before performing this task, we recommend that you read and understand all the installation steps, because there are many AP models and manufacturers available. Each producer strives to make the procedure as simple as possible, but there are cases when it's anything but that.

It is also advisable that you apply a new access point firmware in a steady power environment (UPS unit will satisfy this need), using an Ethernet cable rather than a wireless connection. The latter can be easily interrupted.

With this in mind, if you wish to apply this version, click the download button and install the package on your access point. Remember to check back with our website as often as possible so that you don't miss a single new release.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related Ubiquiti Drivers