NETGEAR WNDAP620 Access Point Firmware 2.0.11 Download

Posted at December 18, 2024 by PCI-DB Team

NETGEAR WNDAP620 Access Point Firmware 2.0.11 Description

Bug Fixes:

- Security vulnerability fixes.
- Fixed the issue where NDAP620 AP doesn't display neighbour APs properly after enabling Rogue AP detection feature.
- Removed the default password change option after the first login in the GUI.

Known Issues:

- The data traffic over WDS will not happen with WPA-PSK and WPA2-PSK authentication when "Enable Client association" option is disabled.
- The data traffic over WDS will not happen with WPA-PSK authentication.

To Install:

- Write down all the settings which you changed from the default values, since you may need to reenter them manually.
- Download and extract the new firmware to a convenient place such as your desktop.
- Login to Web Administration interface of the Access Point.Enter admin for the user name and password for the password.
- Click Maintenance > Upgrade > Firmware Upgrade.
- Click Browse and select the firmware image you just downloaded.
- Click Apply to initiate upgrade process. Note: The upgrade process typically takes at least 6 minutes when upgraded to V2.0.8 / V2.0.11. Any upgrade from V2.0.8 and above firmware version will take approximately 3minutes only.
- WARNING: Do NOT interrupt or power off the computer until the upgrade process is completed. Wait for the AP to reboot.

About Access Points:

If you update the Access Point (AP) firmware, your device can benefit from changes that fix multiple issues encountered by wireless clients, correct different user interface problems, add various functionalities, and include support for newly developed protocols.

Before performing this task, we recommend that you read and understand all the installation steps, because there are many AP models and manufacturers available. Each producer strives to make the procedure as simple as possible, but there are cases when it’s anything but that.

It is also advisable that you apply a new access point firmware in a steady power environment (UPS unit will satisfy this need), using an Ethernet cable rather than a wireless connection. The latter can be easily interrupted.

With this in mind, if you wish to apply this version, click the download button and install the package on your access point. Remember to check back with our website as often as possible so that you don’t miss a single new release. 

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related NETGEAR Drivers