DrayTek VigorIPPBX 2820n (Annex A 243601) IP PBX Router Firmware 3.5.9 Download

Posted at December 18, 2024 by PCI-DB Team

DrayTek VigorIPPBX 2820n (Annex A 243601) IP PBX Router Firmware 3.5.9 Description

New Features

- Show the warning message when USB disk is full in the web page of SysLog / Mail Alert.
- Increase Digit Map rules from 50 to 60; increase prefix number from 11 to 15 digits.

Improvement

- Improved: Resolved compatibility issue between DrayTek IPPBX and GSM gateway.
- Improved: Resolved compatibility issue for BLF function of Snom IP-phone.
- Improved: Resolved call compatibility issue between DrayTek IPPBX and Cisco E20.
- Improved: Correct the voice mail subsystem stop working after running few weeks.
- Improved: Correct EasyGate GSM Gateway and IPPBX's FXO port can not display caller ID issue.
- Improved: Correct holiday answer mode can not work well for SIP Alias and ISDN trunk.
- Improved: Correct IVR can't delete all group messages when accessing via “889” number.
- Improved: Correct WAN Connection Detection on WAN1.
- Improved: Correct maximum number of simultaneous call issue.
- Improved: Correct ext 901 (FXS port) failed to do unattendant call transfer issue, when there were incoming call from PSTN Trunk.
- Improved: Correct missing display name of caller ID for incoming call from SIP trunk.
- Improved: Correct the failure of saving voice mail to WAV file.
- Improved: Correct WUI USB Syslog can't show whole content issue.
- Improved: Correct Call Barring broken with specific configuration.

Known Issue

- When 4-ISDN calls are enabled, it might cause PSTN not having DSP channel to work.
- Use the version after V2154 for VigorTalk ATA24, otherwise it may occur continuous call transfer job and result in VigorIPPBX reboot.
- The incoming FAX from SIP trunk of the DrayTEL (ITSP) and other ITSPs in the UK still needs the resolution for the interoperability with T.38 of Virtual FAX.
- As for the relation between VigorIPPBX router and System Prompt file, refer to FAQ: Please upload the newest System Prompt after upgrading Vigor IPPBX firmware V3.5.X for detailed information.

Notes

- Backup the configuration file before upgrade to this version, for the structure is not compatible when downgrading back to V358 or earlier version.
- For the router with firmware version V356 installed, use DrayTek Firmware Upgrade Utility to upgrade the firmware up to V357 to prevent from system crash. If the router installed with firmware version below V356, simply use the general firmware upgrade procedure to upgrade the firmware to V357.
- To send a fax via IPPBX virtual fax function, you need to use Virtual FAX Utility.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related DrayTek Drivers