DrayTek Vigor3900 Router Firmware 1.0.7.1 Download

Posted at December 22, 2024 by PCI-DB Team

Install Driver Automatically

Device Name	DrayTek Vigor3900 Router Firmware 1.0.7.1
Category	Firmware
Manufacturer	DrayTek
File Size	21.8 MB
Supported OS	OS Independent

DrayTek Vigor3900 Router Firmware 1.0.7.1 Description

Fixes:
- Improved: Support USB-WAN for WAN Profile under the Setting tab in Application>> Dynamic DNS.
- Improved: Support WCF (web content filter) in High Availability (HA) application.
- Improved: Modify the mechanism for IP filter, "if no further match" action.
- Improved: Add a subnet mask setting, 255.255.255.254, for WAN IP configuration.
- Improved: Add to disable negotiation for Fiber WAN under the Interface tab in WAN>>Switch.
- Improved: ‘space’ can be used as the special character in username for LDAP profile.
- Improved: QoS IP rule can apply the packets passing through both Local IP and Remote IP.
- Corrected: Fixed the problem of PPTP keep restarting when multiple PPTP LAN to LAN tunnels are dialing in at the same time.
- Corrected: Can not block / unblock some IPs on Diagnostics>>Data Flow Monitor.
- Corrected: Fixed reboot problem while pinging packet size (more than 8138 bytes) over IPSec LAN to LAN tunnel.
- Corrected: The user can not access Internet when QoS queue weight is set as “0”.
- Corrected: Lower the priority of Inter-LAN routing function.
- Corrected: LAN DHCP packets do not respond while LAN DHCP Server is OFF.
- Corrected: Can’t accept L2TP VPN from none default route WAN.
- Corrected: RADIUS client (Vigor router) sends wrong NAS IP address (127.0.0.1).
- Corrected: The traffic status of DHCP over IPsec shows zero in VPN Connection Management.
- Corrected: ARP detection may fail when WAN TX traffic is full.
- Corrected: SMS can't be sent out when L2TP over IPsec is up and down.

Known Issue

- VPN Trunk tunnel doesn't work well when the profile name is more than 15 characters.
- You need to disable "Force IPsec with L2TP" options for pure L2TP tunnel in VPN and Remote Access >> PPP General Setup.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

Related DrayTek Drivers